Caloffroad Bilstein 75mm Platinum Lift Kit - V8 Landcruiser 78, 79 Series Single Cab Dual Cab & Troop Carrier (2007-On)

This is a Complete 3" Caloffroad Bilstein Platuinum Lift Kit to suit Toyota Landcruiser 78, 79 Series (2007-On) excluding some vehicles as per notes listed below.

For over 50 years Bilstein have been the leaders in Monotube Shock Absorber technology.

Each Bilstein Platinum Series shock absorber is assembled by hand in Germany, and the Platinum Series Offroad shocks are designed and tested in Australia, to suit the harsh conditons that Australia throws at them.

This Kit Contains all components required to perform a 3" Lift

 

The kit contains:

• 2x Caloffroad Bilstein Long Travel Front Shock Absorbers
• 2x Caloffroad Platinum Series Front Coil springs
• 2x Caloffroad Bilstein Long Travel Rear Shock Absorbers
• 2x EFS Leaf Springs
• 1x ABS Wire Relocation Kit
• 1x Brake Proportioning Valve Spacer Block
• 4x HD U Bolts
• 1x Polyurethane Bush Kit
• 1x Swaybar Spacer Kit
• 1x Adjustable Panhard Rod ...... See Notes below Prior to Ordering......
• 1x Caster Correction Bush Kit
• 1x Greasable Pin Kit
• 1x Greasable Shackle Kit

 

Suits:

• Toyota Landcruiser 79 Series Single Cab V8 (2007-2017)
• Toyota Landcruiser 78 Series Troop Carrier V8 (2007-On)
• Toyota Landcruiser 79 Series Dual Cab V8 (2007-On)

Notes Before Ordering:

• If your vehicle was built after 2015, Please measure the length of your front factory Panhard rod. This kit will NOT FIT if your factory panhard rod is 810mm long (from the centre of both eyes).
• It will only fit if your factory panhard rod is 940mm (from the centre of both eyes).
• NOTE: Do NOT Order this kit if you have the Shorter 810mm Long Panhard Rod, as this kit is NOT suitable for your Vehicle.

 

--

Important Notes for setting up your Vehicle Correctly:

• When selecting Springs to suit your lift, please Select Springs only to suit Current "CONSTANT" Loads Front and Rear.
• Towing Loads are not included in your Constant Load Calculations, as they are not "Constant" Loads.
• Please do not put Occasional Loads into your "Constant" Load determinations.
• Selecting a load rating that is too heavy for your setup will result in Poor Flex Off-Road, Compromised Suspension Travel & Rough Ride, and will cause damage to your new shock absorbers and other components by pushing them outside of their intended range.

 

Please Note:

• All lift heights stated are estimated lift heights, due to the large number of variables in each different vehicles setup and accessories.