Lightforce Headlight Patch Harness - Gen 3 Mazda BT-50 with Factory LED Headlights 09/2020-12/2024 Pre-Facelift

Suitable for use with the Gen 3 Mazda BT-50 with Factory LED Headlights 09/2020-12/2024 Pre-Facelift allowing for easy plug and play integration into the existing factory headlight connector that are located on the back of each side of the vehicle’s headlight assemblies.

Only Compatible with the following Lightforce wiring harnesses.

•  LFDLHTS / LFDLHTS2 - Genesis / Venom
•  LFDLHDS - HTX MK1 / MK2
• STRIKERLEDHARN - Striker LED

DETAILS:

• The adapter uses the factory connection point on the back of the headlight assembly. You no longer need to put a hole in the dust cover or splice a wire into the factory harness for auxiliary driving lights.

Installation:

• Remove the existing factory 6 pin connector from the back of the headlight (left or right side) there is a locking tab that must be depressed while removing the connector.
• Fit the corresponding new connector to the factory connector that has just been removed.
• Fit the remaining new connector to the original factory connector affixed to the headlight assembly.
• Then connect the corresponding connectors from anyone of our listed compatible wiring harnesses.

WIRING:

• Red wire is from the vehicles positive high beam circuit and is used to trigger the positive signal on an auxiliary relay for driving lights.
• Green wire is from the vehicles negative circuit and is used to trigger the negative signal on an auxiliary relay for driving lights.
• Both red & green wires must be connected.
• Blue wire is from the vehicles positive low beam headlight, for uses with positioning lights (fitment optional) or can be used as the pickup point for the switch illumination.