Dobinsons Ultimate 75mm 3" IMS Lift Kit - Jeep Gladiator JT 2018-on

The Dobinsons IMS Monotube lift kit is the ultimate in lift kits for your 4WD. It combines the known quality of Dobinsons components with the performance of a Monotube 60mm bore shock and valved specifically to suit the JT Gladiator. 

For customers that do not need the adjustability of the MRA kit, this is the ideal kit for tremendous ride and flex with your Gladiator. 

This is a complete Dobinsons IMS lift kit for a Jeep Gladiator JT 2018-on.

The kit contains:

• 2x Dobinsons IMS 60mm Bore Monotube Front Shock Absorbers
• 2x Dobinsons Front Coil Springs 75mm Lift
• 2x Dobinsons IMS 60mm Bore Monotube Rear Shock absorbers
• 2x Dobinsons Rear Coil Springs 75mm Lift (Low Load Carrying Option only)
• 2x Dobinsons Front Castor Corrected Lower Control Arms
• 1x Dobinsons Front Sway Bar Extension Kit
• 1x Dobinsons Front Bump Stop Extension (Aids in fitment of 35" Tyres)
• 1x Dobinsons Front Lower Spring Seat (Reduces Coil Spring Bow)
• 1x Dobinsons Rear Bump Stop Extension (Aids in fitment of 35" Tyres)
• 1x Dobinsons Rear Sway Bar Extension Kit
   

Important Notes for setting up your Vehicle Correctly:

• When selecting Springs to suit your lift, please Select Springs only to suit Current "CONSTANT" Loads Front and Rear.
• Towing Loads are not included in your Constant Load Calculations, as they are not "Constant" Loads.
• Please do not put Occasional Loads into your "Constant" Load determinations.
• Selecting a load rating that is too heavy for your setup will result in Poor Flex Off-Road, Compromised Suspension Travel & Rough Ride, and will cause damage to your new shock absorbers and other components by pushing them outside of their intended range.

Please Note:

• All lift heights stated are estimated lift heights, due to the large number of variables in each different vehicles setup and accessories. 
• Estimated igt Height 75mm 3"