Dobinsons MRR 75mm Raised Front Pre-Assembled Struts - Mazda BT-50 11/2011-08/2020

This is a Dobinsons Monotube Remote Reservoir Front Lift Kit for a Mazda BT-50 11/2011-08/2020

The Dobinsons MRR lift kit is the ultimate in lift kits for your 4WD. It combines the known quality of Dobinsons components with the performance of a Monotube Remote Reservoir 50mm bore shock and is height adjustable, meaning you can fine tune your ride height to your desired look, or to increase lost height when new accessories have been fitted

The kit contains:

• 2x Dobinsons MRR Struts
• 2x Dobinsons Front Coil Springs
• 2x Dobinsons Coilover Adjusting "C" Spanners
• 2x New Strut Top Mounts & Pre-Assembly of Struts

--

Important Notes for setting up your Vehicle Correctly:

• When selecting Springs to suit your lift, please Select Springs only to suit Current "CONSTANT" Loads Front and Rear.
• Towing Loads are not included in your Constant Load Calculations, as they are not "Constant" Loads.
• Please do not put Occasional Loads into your "Constant" Load determinations.
• Selecting a load rating that is too heavy for your setup will result in Poor Flex Off-Road, Compromised Suspension Travel & Rough Ride, and will cause damage to your new shock absorbers and other components by pushing them outside of their intended range.

Please Note:

• All lift heights stated are estimated lift heights, due to the large number of variables in each different vehicles setup and accessories. 
• Estimated Lift Height 75mm 3"
• If you are after 50mm 2" Raised Struts, please see our Other Listings.