Dobinsons Nitro Gas 40-45mm Lift Kit - Isuzu MU-X UCS40 (08/2021-On)

This is a complete Dobinsons Suspension Lift Kit to suit a Isuzu MU-X UCS40 (08/2020-On)

The base kit Includes:

• 2x Dobinsons Nitro Gas Struts (Front)
• 2x Dobinsons Springs Raised Front Coil Springs
• 2x Dobinsons Nitro Gas Shocks (Rear)
• 2x Dobinsons Springs Raised Rear Coil Springs

Important Notes for setting up your Vehicle Correctly:

• When lifting the Front in these they are very sensitive to changes on Height with the Steering Geometry.
• They will sit Extremely High with Bad Toe in and Positive Camber until wheel aligned.
• ** It is Critical not to fit Heavy Duty Springs to suit Accessories that are not fitted yet fitted, or you are going to have problems with alignment and electronics **
• We recommend fitting Accessories 1^st and then set the Suspension up to cope with them.
• Front Ride Height can vary by as much as 20-25mm before and after alignment on this model.
• Height Measurements cannot be done until the vehicle is wheel aligned.
• We recommend vehicles are not driven until they are Wheel aligned.
• When selecting Springs to suit your lift, please Select Springs only to suit Current "CONSTANT" Loads Front and Rear.
• Towing Loads are not included in your Constant Load Calculations, as they are not "Constant" Loads.
• Please do not put Occasional Loads into your "Constant" Load determinations.
• Selecting a load rating that is too heavy for your setup will result in Poor Flex Off-Road, Compromised Suspension Travel & Rough Ride, and will cause damage to your new shock absorbers and other components by pushing them outside of their intended range.